Iron making by Linz-Donawitz-Verfahren process

It is also known as the Basic oxygen processes or Oxygen converter method. It is usually denoted by BOS process. And commonly, It is also known as LD converter method. It is the moderate form or type of Bessemer converter, the main different is that in Bessemer converter air is used and in this method oxygen I used instead of air. Today most of the steel or iron is produced by this process due to the low cost, less time consuming and better quality.

The basic oxygen steel-making process is as follows:

Molten pig iron from a blast furnace is poured into a large refractory-lined container called a ladle. The metal in the ladle is sent directly for basic oxygen steelmaking or to a pretreatment stage. Pretreatment of the blast furnace metal is used to reduce the refining load of sulfur, silicon, and phosphorus. In desulfurizing pretreatment, a lance is lowered into the molten iron in the ladle and several hundred kilograms of powdered magnesium are added. Sulfur impurities are reduced to magnesium sulfide in a violent exothermic reaction. The sulfide is then raked off. Similar pretreatment is possible for desiliconisation and dephosphorisation using iron oxide and lime stone as reducing agent. The decision to pretreat depends on the quality of the blast furnace metal and the required final quality of the Basic Oxygen Steel making process (BOS). Filling the furnace with the ingredients is called charging. The BOS process is autogenously (the required thermal energy is produced during the process). Maintaining the proper charge balance, the ratio of hot metal to scrap, is therefore very important. The BOS vessel is one-fifth filled with steel scrap. Molten iron from the ladle is added as required by the charge balance. A typical chemistry of hot metal charged into the BOS vessel is 4% C, 0.2–0.8% Si, 0.08%–0.18% P, and 0.01–0.04% S. The vessel is then set upright and a water-cooled lance is lowered down into it. The lance blows 99% pure oxygen onto the steel and iron, igniting the carbon dissolved in the steel and burning it to form carbon monoxide and carbon dioxide, causing the temperature to rise to about 1700°C. This melts the scrap, lowers the carbon content of the molten iron and helps remove unwanted chemical elements. It is this use of oxygen instead of air that improves upon the Bessemer process, for the nitrogen (and other gases) in air does not react with the charge as oxygen does. High purity oxygen is blown into the furnace or BOS vessel through a vertically oriented water-cooled lance with velocities faster than Mach 1. Fluxes (which burnt lime stone or dolomite) are fed into the vessel to form slag, which absorbs impurities of the steelmaking process. During blowing the metal in the vessel forms an emulsion with the slag, facilitating the refining process. Near the end of the blowing cycle, which takes about 20 minutes, the temperature is measured and samples are taken. The samples are tested and a computer analysis of the steel given within six minutes. A typical chemistry of the blown metal is 0.3–0.6% C, 0.05–0.1% Mn, 0.01–0.03% Si, 0.01–0.03% S and P. The BOS vessel is tilted again and the steel is poured into a giant ladle. This process is called tapping the steel.

The steel is further refined in the ladle furnace, by adding alloying materials to give the steel special properties required by the customer. Sometimes argon or nitrogen gas is bubbled into the ladle to make sure the alloys mix correctly. The steel now contains 0.1–1% carbon. The more carbon in the steel, the harder it is, but it is also more brittle and less flexible. After the steel is removed from the BOS vessel, the slag, filled with impurities, is poured off and cooled.